A pallet rolls forward on a conveyor line in Odessa, Texas.
A retired solar panel moves into position, its glass cracked and its cells dulled by years of sun.
A machine shears the aluminum frame away in seconds.
The step is called deframing, the first cut in a chain meant to pull a dead panel apart piece by piece.
Industry material sheets say a panel like this one is up to 95 percent recyclable by weight.
So why does so little of it actually get recovered?
Why the recoverable share and the recovered share are not the same number
The 95 percent figure describes what is inside a panel, not what comes back out of one. Glass alone makes up roughly three quarters of a panel’s weight, and aluminum frames are almost entirely recoverable, so the theoretical ceiling really is high.
The trouble is that very few retired panels in the United States ever reach a facility capable of hitting that ceiling. There are no federal rules requiring it, and less than 10 percent of the country’s decommissioned panels are recycled, according to the National Renewable Energy Laboratory. European law sets a recovery target of 85 percent by weight, but that target applies to panels that are actually collected, not to every panel that comes off a roof or a field.
So the headline number is not false, it is just the wrong question answered. A panel being almost entirely recyclable says nothing about whether anyone can afford to do it at scale.
One Texas plant pushing toward a million panels a year
At the Odessa site, panels run through a sequence that pulls off the frame, separates the glass, and isolates the silicon, silver and copper hidden in each cell. The company behind it has been expanding that plant toward one million panels a year, tens of millions of pounds of retired hardware moving through a single building.
That is a serious operation. Yet even a plant running at that pace barely dents the wave of panels installed during the solar boom of the last fifteen years, most of which are only now approaching the end of a typical 25 to 30 year lifespan.
Which is why the same company built a second, far larger site. A 255,000 square foot facility in Cedartown, Georgia, is designed to handle up to ten million panels a year at full capacity, about five gigawatts of retired material passing through one campus.
The Georgia line that opened processing panels in January 2026
The Georgia plant began processing panels on a next generation line the company says more than doubles the throughput of its first generation equipment. By its own account the process sends nothing to landfill and recovers about 96 percent of the value locked in a panel’s silver, copper, aluminum and glass. The design target announced earlier was up to 99 percent of a panel’s materials, including bifacial silicon panels; both figures are company claims rather than audited results.
The recovered glass is meant to feed a solar glass factory planned on the same campus, closing the loop between an old panel’s shell and a new one’s glass sheet. That factory is still being built, and the company says it has commitments for more than 80 percent of its planned capacity.
At full build, the recycling plant is pitched as enough to handle an estimated 25 to 30 percent of all US panels retiring by the end of the decade, a share that sounds modest until you remember it would come from one site.
Why actual volumes still trail the million panel goal
Actual throughput has stayed well short of nameplate numbers. The company’s annual impact data put 2024 at 480,406 panels recycled, with a stated goal of one million in 2025 and two million in 2026, and more than 90 energy companies signed on as customers. The Georgia line opened processing thousands of panels a week, scaling toward a million a year by the end of 2026.
Set against the scale of installed US solar, those figures are small, and it is exactly the gap the recyclability percentage conceals. A ceiling of 95 or 99 percent means little if the panel never physically arrives at a facility built to extract it.
Contracts with utility scale operators are meant to close that gap panel by panel. One partnership covers roughly 1 million panels from 375 megawatts of Midwest projects, an estimated 48 million pounds of material diverted from landfills, the same logistical problem that follows decade old rooftop panels stripped for their silver content.
Whether capacity can outrun a decade of retirements
None of this makes the 95 percent figure untrue. It is a real ceiling, measured by weight and approached on working recycling lines. The caveat is that the number everyone repeats describes a material’s potential, while the number that matters to a landfill is what share of panels ever reach a line at all.
That gap is narrowing as facilities scale from hundreds of thousands of panels toward the millions needed to keep pace with the boom years. Whether capacity can outrun the retirement wave remains an open question, not unlike the uncertainty still facing other emerging power technologies proving out their long term numbers.
For now, the honest version of the claim is simpler than the marketing slide.
A solar panel can be almost entirely recycled. Most of them, in this country, still are not.
Read the whole thing?
Get the week's signal, not the noise
Our sharpest reporting on energy, climate and nature — free, once a week.